ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Pull out pins -3- as far as stop using release tool -T10236-.
– Pull retaining clips -4- out of spring control arm -1- using
release tool -T10236-.
– Pull stone deflector for spring control arm -2- at spreader
rivets -5- off spring control arm -1-, and remove it.
Removing
Install in reverse order of removal, observing the following:
– Pay attention to allocation “L”, “R” and arrow denoting direc‐
tion of travel.
Tightening torques
♦ ⇒ Rep. gr. 42; Assembly overview – spring control arm
5.5
Assembly overview – spring control arm
5. Suspension link, track rod
151
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
1 - Nut
❑ Renew after removing
❑ M14 × 1.5
2 - Spring control arm
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing spring
control arm
3 - Bolt
❑ Renew after removing
❑ M14 × 1.5 × 90
❑ 130 Nm +180°
4 - Eccentric washer
5 - Nut
❑ Renew after removing
❑ M14 × 1.5
❑ 160 Nm
6 - Eccentric bolt
❑ M14 × 1.5 × 97
7 - Stone deflector for spring
control arm
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing stone
deflector for spring con‐
trol arm
8 - Spreader rivet
❑ Qty. 2
9 - Bolt
❑ Qty. 2
❑ 2 Nm
10 - Retaining clip
❑ Qty. 2
❑ Renew after removing
5.6
Removing and installing spring control
arm
Special tools and workshop equipment required
♦ engine and gearbox jack -VAS 6931-
♦ gearbox support -T10337-
Removing
The rear left vehicle level sender -G76- will henceforth be refer‐
red to as “rear left vehicle level sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– ⇒ Rep. gr. 44; Remove wheel.
– Remove stone deflector for spring control arm ⇒ Rep. gr. 42;
Removing and installing stone deflector for spring control
arm.
152
Rep. gr.42 - Rear suspension
2024 VW ID.4 Owner's Manual
