ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Push protective tube -1- to stop onto shock absorber mount‐
ing -2-.
– Fit cable tie -3- and tighten.
Important
•
The fastener -arrow- of the cable tie -3- must be located
within area -a-.
•
Closure -arrow- of cable tie must point outwards when shock
absorber is installed.
– Install cover -1- to shock absorber mounting -2-, and ensure
that it is seated firmly.
Tightening torques
♦ ⇒ o6.4 verview – shock absorber”, page 167
6.3
Assembly overview – spring
The overview is shown for the left side of vehicle as an exam‐
ple.
166
Rep. gr.42 - Rear suspension
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
1 - Spring
❑ Depending on equip‐
ment/version
❑ For allocation, refer to
⇒ Electronic parts cata‐
logue “ETKA”
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing spring
2 - Spring seat
3 - Support
4 - Spring seat
5 - Spring control arm
❑ ⇒ Rep. gr. 42; Assem‐
bly overview – spring
control arm
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing spring
control arm
6 - Retaining clip
7 - Guides
6.4
Assembly overview – shock absorber
The overview is shown for the left side of vehicle as an exam‐
ple.
6. Suspension strut, shock absorber, spring
167
2024 VW ID.4 Owner's Manual
