ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
♦ ⇒ Electric rear-wheel drive EIP220 and all-wheel drive
EIA200, EIP220; Rep. gr. 93; Voltage converter; Assembly
overview – voltage converter
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Underbody
cladding; Assembly overview – underbody cladding
♦ ⇒ Wheels and Tyres Guide; Rep. gr. 44; Wheels, tyres;
Specified torque for wheel bolts
♦ ⇒ Rep. gr. 63; Front bumper; Assembly overview – impact
bar
3.2
Repairing thread in longitudinal mem‐
ber
Repairing the thread in welded nuts in the longitudinal member
is possible under certain conditions; Body repair ⇒ Body Re‐
pairs; Rep. gr. 50.
3.3
Fixing subframe in position
Special tools and workshop equipment required
♦ stud -T10486/1-
♦ threaded pin -T10486/1-
NOTICE
If the subframe is removed, the axle settings may change.
This can influence the driving behaviour of the vehicle.
– Secure the subframe in its exact position relative to the
body using 4 threaded pins.
– ⇒ Rep. gr. 40; Take up weight of subframe via scissor-type
assembly platform.
– Unscrew bolts -4-.
– Unscrew bolts -5-.
– Remove support plate -3-.
– Screw threaded pin -T10486/1--A- into outer hole on left side
of subframe -1-.
10
Rep. gr.40 - Front suspension
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Tighten threaded pin -T10486/1--A- to 20 Nm.
– Unscrew bolts -2-.
– Unscrew bolts -6-.
– Remove support plate -1-.
– Screw threaded pin -T10486/1--A- into outer hole on right
side of subframe -1-.
3. Subframe
11
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Tighten threaded pin -T10486/1--A- to 20 Nm.
– Unscrew bolt -2- on left side of vehicle.
– Screw in threaded pin -T10486/1- -A-, and tighten it to
20 Nm.
– Unscrew bolt -3- on right side of vehicle.
12
Rep. gr.40 - Front suspension
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Screw in threaded pin -T10486/1--A-, and tighten it to
20 Nm.
Installing
Install in reverse order of removal, observing the following:
– Only ever unscrew one stud -T10486/1- at a time and re‐
place it with a new bolt.
If the steering wheel is found to be off centre during the road
test, check wheel alignment.
Tightening torques
♦ ⇒ Rep. gr. 40; Assembly overview – subframe
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Underbody
cladding; Assembly overview – underbody cladding
3.4
Taking up weight of subframe using
scissor-type assembly platform
Special tools and workshop equipment required
♦ scissor-type assembly platform -VAS 6131B-
3. Subframe
13
2024 VW ID.4 Owner's Manual
