ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Disconnect electrical connector -3-.
– Unclip control unit -1- on right side -arrow-.
– Pull control unit -1- in direction of -arrow- out of bracket -2- .
Installing
Install in reverse order of removal, observing the following:
– After the control unit has been renewed, conclude the test
plan for the renewal of the control unit using ⇒ Vehicle diag‐
nostic tester.
Tightening torques
♦ ⇒ General body repairs, interior; Rep. gr. 70; Luggage com‐
partment trims; Assembly overview – luggage compartment
side trim
2.4
Removing and installing front body ac‐
celeration senders [G341]/[G342]
Removing
The front left body acceleration sender -G341- and front right
body acceleration sender -G342- will henceforth be referred to
as “front body acceleration sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Disconnect electrical connector -2-.
206
Rep. gr.43 - Self-levelling suspension
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Unscrew bolt -3- from bracket -4-, and remove front body
acceleration sender -1-.
Installing
Install in reverse order of removal, observing the following:
– Insert guide on front body acceleration sender -1- correctly
into bracket -4-.
– Carry out basic setting for wheel damper electronics using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – electronically controlled
damping
2.5
Removing and installing rear body ac‐
celeration sender [G343]
Removing
The rear body acceleration sender -G343- will henceforth be
referred to as “rear body acceleration sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Remove rear left sill panel moulding ⇒ General body repairs,
interior; Rep. gr. 70; Trims, interior; Removing and installing
sill panel moulding at rear.
– Disconnect electrical connector -3-.
2. Electronically controlled damping
207
2024 VW ID.4 Owner's Manual
