ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
1 - Bolt
❑ 5 Nm
2 - Rear left vehicle level
sender -G76-
❑ ⇒ Rep. gr. 43; Remov‐
ing and installing rear
vehicle level senders
[G76]/[G77]
3 - Electrical connector
4 - Spring control arm
❑ ⇒ Rep. gr. 42; Assem‐
bly overview – spring
control arm
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing spring
control arm
5 - Stud
❑ 5 Nm
6 - Pop rivet nut
7 - Subframe
❑ ⇒ Rep. gr. 42; As‐
sembly overview – sub‐
frame
❑ ⇒ Rep. gr. 42; Fixing
subframe in position
❑ ⇒ Rep. gr. 42; Taking
up weight of subframe
using scissor-type as‐
sembly platform
❑ ⇒ Rep. gr. 42; Remov‐
ing and installing rear
axle
3.3
Removing and installing front vehicle
level senders [G78]/[G289]
Removing
The front left vehicle level sender -G78- and front right vehicle
level sender -G289- will henceforth be referred to as “front vehi‐
cle level sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Remove front body acceleration sender ⇒ Rep. gr. 43;
Removing and installing front body acceleration senders
[G341]/[G342].
– Remove stone deflector for suspension link ⇒ Rep. gr. 40;
Removing and installing stone deflector for suspension link.
– Disconnect electrical connector -2-.
3. Vehicle level sender
211
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Unscrew nuts -2-.
– Unclip wiring harness -3- from bracket -1-.
– Remove bracket -1- with front vehicle level sender.
Installing
Install in reverse order of removal, observing the following:
The lever of the front vehicle level sender -1- must point to‐
wards the outer side of the vehicle.
– Insert guide -5- on front vehicle level sender -1- into inner
hole of suspension link -4-.
212
Rep. gr.43 - Self-levelling suspension
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Insert threaded end of front vehicle level sender -1- into
outer hole of suspension link -4-.
– Carry out basic setting for front vehicle level sender using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – front vehicle level send‐
ers
♦ ⇒ Rep. gr. 43; Assembly overview – electronically controlled
damping
3.4
Removing and installing rear vehicle
level senders [G76]/[G77]
Removing
The rear left vehicle level sender -G76- will henceforth be refer‐
red to as “rear vehicle level sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Remove stone deflector for spring control arm ⇒ Rep. gr. 42;
Removing and installing stone deflector for spring control
arm.
– Disconnect electrical connector -3-.
3. Vehicle level sender
213
2024 VW ID.4 Owner's Manual
