ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Unscrew bolt -3- from bracket -4-, and remove front body
acceleration sender -1-.
Installing
Install in reverse order of removal, observing the following:
– Insert guide on front body acceleration sender -1- correctly
into bracket -4-.
– Carry out basic setting for wheel damper electronics using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – electronically controlled
damping
2.5
Removing and installing rear body ac‐
celeration sender [G343]
Removing
The rear body acceleration sender -G343- will henceforth be
referred to as “rear body acceleration sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Remove rear left sill panel moulding ⇒ General body repairs,
interior; Rep. gr. 70; Trims, interior; Removing and installing
sill panel moulding at rear.
– Disconnect electrical connector -3-.
2. Electronically controlled damping
207
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Unscrew bolt -4-, and remove rear body acceleration sender
-1-.
Installing
Install in reverse order of removal, observing the following:
– Insert guide on rear body acceleration sender -1- into recess
in body -arrow-.
– Carry out basic setting for wheel damper electronics using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – electronically controlled
damping
2.6
Assembly overview - electronically controlled damping
The overview is shown for the left side of vehicle as an exam‐
ple.
208
Rep. gr.43 - Self-levelling suspension
2024 VW ID.4 Owner's Manual
