ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Insert threaded end of front vehicle level sender -1- into
outer hole of suspension link -4-.
– Carry out basic setting for front vehicle level sender using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – front vehicle level send‐
ers
♦ ⇒ Rep. gr. 43; Assembly overview – electronically controlled
damping
3.4
Removing and installing rear vehicle
level senders [G76]/[G77]
Removing
The rear left vehicle level sender -G76- will henceforth be refer‐
red to as “rear vehicle level sender”.
Removal and installation are described for the left side of vehi‐
cle as an example.
– Remove stone deflector for spring control arm ⇒ Rep. gr. 42;
Removing and installing stone deflector for spring control
arm.
– Disconnect electrical connector -3-.
3. Vehicle level sender
213
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Unscrew bolt -1-.
– Unscrew stud -5- from spring control arm -4-.
– Remove rear vehicle level sender -2-.
Installing
Install in reverse order of removal, observing the following:
The lever of rear vehicle level sender must point to outer side of
vehicle.
– Insert vehicle level sender -2- in guide -8- on subframe -7-.
– Carry out basic setting for rear vehicle level sender using
⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ Rep. gr. 43; Assembly overview – rear vehicle level send‐
ers
♦ ⇒ Rep. gr. 42; Assembly overview – spring control arm
214
Rep. gr.43 - Self-levelling suspension
2024 VW ID.4 Owner's Manual
