ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
♦ ⇒ Electric rear-wheel drive EIP220 and all-wheel drive
EIA200, EIP220; Rep. gr. 93; Voltage converter; Assembly
overview – voltage converter
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Underbody
cladding; Assembly overview – underbody cladding
♦ ⇒ Wheels and Tyres Guide; Rep. gr. 44; Wheels, tyres;
Specified torque for wheel bolts
♦ ⇒ Rep. gr. 63; Front bumper; Assembly overview – impact
bar
3.2
Repairing thread in longitudinal mem‐
ber
Repairing the thread in welded nuts in the longitudinal member
is possible under certain conditions; Body repair ⇒ Body Re‐
pairs; Rep. gr. 50.
3.3
Fixing subframe in position
Special tools and workshop equipment required
♦ stud -T10486/1-
♦ threaded pin -T10486/1-
NOTICE
If the subframe is removed, the axle settings may change.
This can influence the driving behaviour of the vehicle.
– Secure the subframe in its exact position relative to the
body using 4 threaded pins.
– ⇒ Rep. gr. 40; Take up weight of subframe via scissor-type
assembly platform.
– Unscrew bolts -4-.
– Unscrew bolts -5-.
– Remove support plate -3-.
– Screw threaded pin -T10486/1--A- into outer hole on left side
of subframe -1-.
10
Rep. gr.40 - Front suspension
2024 VW ID.4 Owner's Manual
