ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
– Screw in threaded pin -T10486/1--A-, and tighten it to
20 Nm.
Installing
Install in reverse order of removal, observing the following:
– Only ever unscrew one stud -T10486/1- at a time and re‐
place it with a new bolt.
If the steering wheel is found to be off centre during the road
test, check wheel alignment.
Tightening torques
♦ ⇒ Rep. gr. 40; Assembly overview – subframe
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Underbody
cladding; Assembly overview – underbody cladding
3.4
Taking up weight of subframe using
scissor-type assembly platform
Special tools and workshop equipment required
♦ scissor-type assembly platform -VAS 6131B-
3. Subframe
13
ID.4 2021 ➤
Running gear, axles, steering - Edition 05.2021
Removing
– ⇒ Rep. gr. 40; Prepare scissor-type assembly platform.
– Position scissor-type assembly platform -VAS 6131B--A-
longitudinally under vehicle, align it, and raise it.
– Position supports -2- and -4- on subframe -1- as shown in
illustration.
– Adjust height of supports -2- and -4-.
– Raise scissor-type assembly platform -VAS 6131B--A- fur‐
ther.
– Align supports -4- with holes on right side of subframe -1-.
– Align supports -2- with holes on left side of subframe -1-.
– Tighten bolts for supports -2- and -4- on scissor-type assem‐
bly platform -VAS 6131B--A- to 40 Nm.
– Align support -3- with cross member at rear of subframe -1-.
– Align height of supports -2-, -3- and -4-, and bolt them on.
– Raise scissor-type assembly platform -VAS 6131B- further,
and support subframe -1-.
3.5
Preparing scissor-type assembly plat‐
form
Special tools and workshop equipment required
♦ Plate -VAS 6131/10-1-
♦ Scissor-type assembly platform -VAS 6131B-
♦ Spindle -VAS 6131/10-5-
♦ Support set for Audi -VAS 6131/10-7-
♦ Universal support -VAS 6131/13-2-
♦ scissor-type assembly platform -VAS 6131B-
Removing
Prepare supports 1:
– Assemble supports as shown using the following tools:
14
Rep. gr.40 - Front suspension
2024 VW ID.4 Owner's Manual
