ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
14
Vehicle noise/engine sound
14.1
Overview of fitting locations – driving sound/motor sound
1 - Engine sound generator
module 2 -RX22-
❑ With actuator 2 for en‐
gine sound generator -
R258-
❑ With engine sound gen‐
erator control unit 2 -
J1167-
❑ Depending on equip‐
ment/version
❑ ⇒ Rep. gr. 93; Remov‐
ing and installing en‐
gine sound generator
module
2 - Bolt
❑ Qty. 3
❑ 8 Nm
3 - Electrical connector
4 - Nut
❑ 8 Nm
5 - Bracket
6 - Bolt
❑ Qty. 3
❑ 8 Nm
7 - Bracket
8 - Bolt
❑ Qty. 3
❑ 8 Nm
9 - Electrical connector
10 - Engine sound generator
module 1 -RX21-
❑ With actuator 1 for engine sound generator -R257-
❑ With engine sound generator control unit -J943-
❑ ⇒ Rep. gr. 93; Removing and installing engine sound generator module
14. Vehicle noise/engine sound
267
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
14.2
Removing and installing engine sound
generator module
14.2.1
Removing and installing engine sound
generator module 1 [RX21]
Removing
– Remove front underbody cladding ⇒ General body repairs,
exterior; Rep. gr. 66; Underbody cladding; Removing and
installing front underbody cladding.
– Remove front right wheel housing liner ⇒ General body re‐
pairs, exterior; Rep. gr. 66; Wheel housing liner; Removing
and installing front wheel housing liner.
– Disconnect electrical connector -4-.
– Unscrew nuts -2-.
– Remove engine sound generator module 1 -RX21- -1- from
bracket -3-.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
♦ ⇒ Rep. gr. 93; Overview of fitting locations – driving sound/
motor sound
14.3
Removing and installing engine sound
generator module
14.3.1
Removing and installing engine sound
generator module 2 [RX22]
Removing
268
Rep. gr.93 - Electric drive systems
2024 VW ID.4 Owner's Manual
