ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
Stage Bolts
Specified torque/turning further angle
1
2
-1- to -7- tighten by hand up to stop
-1- to -7- 6 Nm
7.4
Removing and installing drive motor ro‐
tor position sender, rear-wheel drive
7.4.1
Removing and installing drive motor ro‐
tor position sender 1 [G713]
The drive motor rotor position sender 1 -G713- will henceforth
be referred to as “sender”.
Note
Bolts could fall into the motor. Turn the motor to horizontal
position.
Removing
– Remove power and control electronics for electric drive -
JX1- ⇒ Rep. gr. 93; Removing and installing power and con‐
trol electronics for electric drive, rear-wheel drive.
– Unscrew bolts -arrows- for sender -A-.
– Pull sender -A- off connection -2- -arrow-.
Installing
– Fit sender -A- onto connection -2- -arrow-.
7. Electric drive motor
237
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
– Make sure that sender -A- is properly seated on dowel pin
-arrow-.
– Insert bolts -1- and -2-.
– First tighten bolts -1- and then bolts -2-.
– Install power and control electronics for electric drive - JX1-
⇒ Rep. gr. 93; Removing and installing power and control
electronics for electric drive, rear-wheel drive.
Tightening torques
♦ ⇒ Rep. gr. 93; Assembly overview – electric drive motor
7.5
Removing and installing drive motor ro‐
tor position sender, all-wheel drive
7.5.1
Removing and installing drive motor ro‐
tor position sender 1 [G713]
The drive motor rotor position sender 1 -G713- will henceforth
be referred to as “sender”.
Note
Bolts could fall into the motor. Turn the motor to horizontal
position.
238
Rep. gr.93 - Electric drive systems
2024 VW ID.4 Owner's Manual
