Table of Contents > Electric drive systems > Vehicle noise/engine sound > Removing and installing engine sound generator module

VW ID.4 Electric rear-wheel and all-wheel drive ➜ Removing and installing engine sound generator module

ID.4 2021 ➤, ID.3 2020 ➤

Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021

14.2

Removing and installing engine sound

generator module

14.2.1

Removing and installing engine sound

generator module 1 [RX21]

Removing

– Remove front underbody cladding ⇒ General body repairs,

exterior; Rep. gr. 66; Underbody cladding; Removing and

installing front underbody cladding.

– Remove front right wheel housing liner ⇒ General body re‐

pairs, exterior; Rep. gr. 66; Wheel housing liner; Removing

and installing front wheel housing liner.

– Disconnect electrical connector -4-.

– Unscrew nuts -2-.

– Remove engine sound generator module 1 -RX21- -1- from

bracket -3-.

Installing

Install in reverse order of removal, observing the following:

Tightening torques

♦ ⇒ Rep. gr. 93; Overview of fitting locations – driving sound/

motor sound

14.3

Removing and installing engine sound

generator module

14.3.1

Removing and installing engine sound

generator module 2 [RX22]

Removing

268

Rep. gr.93 - Electric drive systems

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.

Ask your question on the page - Support!

ALL VW ID.4 OWNER'S MANUALS

2024 VW ID.4 Owner's Manual

2023 VW ID.4 Owner's Manual

2022 VW ID.4 Owner's Manual

2021 VW ID.4 Owner's Manual

2020 VW ID.4 Owner's Manual

2019 VW ID.4 Owner's Manual

VW ID.4 Service & Repair Manual

VW ID.4 Electric rear-wheel and all-wheel drive ➜ Removing and installing engine sound generator module

Need help?

Useful links

Follow Us