Table of Contents > Removing and installing engine > Front assembly mountings > Removing and installing motor mountings

VW ID.4 Electric rear-wheel and all-wheel drive ➜ Removing and installing motor mountings

ID.4 2021 ➤, ID.3 2020 ➤  
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021  
4
Front assembly mountings  
4.1  
Removing and installing motor mount‐  
ings  
⇒ Running gear, axles, steering; Rep. gr. 40; Subframe; Re‐  
newing motor mountings (front).  
4.2  
Removing and installing gearbox  
mountings  
Removing  
– ⇒ Rep. gr. 10; Removing front motor.  
– Remove bolts -arrows- and detach gearbox mounting -1-.  
Installing  
Installation is carried out in reverse order; note the following:  
Tightening torques  
♦ ⇒ Rep. gr. 10; Assembly overview – front motor  
44  
Rep. gr.10 - Removing and installing engine  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!