Table of Contents > Cooling > Radiator, radiator fan > Removing and installing control motor for radiator roller blind [V711], ID.4

VW ID.4 Electric rear-wheel and all-wheel drive ➜ Removing and installing control motor for radiator roller blind [V711], ID.4

ID.4 2021 ➤, ID.3 2020 ➤  
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021  
– Unscrew bolts -arrows-.  
– Remove control motor -1-.  
Installing  
– Fit control motor -1- in position. If the drive pin of the control  
motor does not fit into the material shaft, turn the material  
shaft slightly.  
– Tighten control motor -arrows-.  
– Connect electrical connector -2-.  
– Install lock carrier ⇒ General body repairs, exterior; Rep.  
gr. 50; Lock carrier; Removing and installing lock carrier.  
If the control motor for radiator roller blind -V711- has been  
renewed:  
– Carry out function “Renew control motor for radiator roller  
blind” using ⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Ac‐  
cess to diagnoses.  
Continued  
Tightening torques  
♦ ⇒ Rep. gr. 19; Assembly overview - radiator/radiator fan  
4.8  
Removing and installing control motor  
for radiator roller blind [V711], ID.4  
4.8.1  
Removing and installing control motor  
for radiator roller blind [V711]  
Removing  
The control motor for radiator roller blind - V711- will henceforth  
be referred to as “control motor”.  
102  
Rep. gr.19 - Cooling  
ID.4 2021 ➤, ID.3 2020 ➤  
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021  
The upper bolt of the control motor is unscrewed through the  
opening in the lock carrier -3-.  
– Disconnect electrical connector -2-.  
– Unscrew bolts -arrows-.  
– Remove control motor -1-.  
Installing  
– Fit control motor -1- in position. If the drive pin of the control  
motor does not fit into the material shaft, turn the material  
shaft slightly.  
– Tighten bolts -arrows-.  
– Connect electrical connector -2-.  
If the control motor for radiator roller blind -V711- has been  
renewed:  
– Carry out function “Renew control motor for radiator roller  
blind” using ⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Ac‐  
cess to diagnoses.  
4. Radiator, radiator fan  
103  
ID.4 2021 ➤, ID.3 2020 ➤  
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021  
Continued  
Tightening torques  
♦ ⇒ Rep. gr. 19; Assembly overview - radiator/radiator fan  
104  
Rep. gr.19 - Cooling  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!