Table of Contents > Cooling > Radiator, radiator fan > Removing and installing radiator fan VX57

VW ID.4 Electric rear-wheel and all-wheel drive ➜ Removing and installing radiator fan VX57

ID.4 2021 ➤, ID.3 2020 ➤  
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021  
– Pull radiator cowl -2- off radiator upwards in direction of  
-arrow B-.  
– Tilt radiator cowl -2- and lift it out.  
Continued  
Installing  
Installation is carried out in reverse order; note the following:  
– Fit radiator cowl on radiator and engage.  
– Reset service position of impact bar ⇒ General body repairs,  
exterior; Rep. gr. 63; Bumper (front); Moving impact bar into  
service position and resetting.  
4.6  
Removing and installing radiator fan  
VX57  
Removing  
– Remove radiator cowl with radiator fan -VX57- ⇒ Rep.  
gr. 19; Removing and installing radiator cowl with radiator  
fans.  
– Detach electrical wire -1- from radiator cowl.  
– Unscrew bolts -arrows-.  
– Detach radiator fan -VX57--2- from radiator cowl.  
Installing  
Install in reverse order of removal, observing the following:  
Tightening torques  
♦ ⇒ Rep. gr. 19; Assembly overview – radiator cowl and radia‐  
tor fan  
4.7  
Removing and installing control motor  
for radiator roller blind [V711], ID.3  
4.7.1  
Removing and installing control motor  
for radiator roller blind [V711]  
Removing  
The control motor for radiator roller blind - V711- will henceforth  
be referred to as “control motor”.  
– Remove lock carrier ⇒ General body repairs, exterior; Rep.  
gr. 50; Lock carrier; Removing and installing lock carrier.  
– Disconnect electrical connector -2-.  
4. Radiator, radiator fan  
101  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!