ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
1 - Bolt
❑ Qty. 3
❑ 6 Nm
2 - Radiator cowl
❑ ⇒ Rep. gr. 19; Remov‐
ing and installing radi‐
ator cowl with radiator
fans
3 - Radiator fan -VX57-
❑ With radiator fan con‐
trol unit -J293-
❑ With radiator fan -V7-
❑ ⇒ Rep. gr. 19; Remov‐
ing and installing radia‐
tor fan VX57
4.3
Removing and installing radiator mod‐
ule
Removing
– Remove front underbody cladding ⇒ General body repairs,
exterior; Rep. gr. 66; Underbody cladding; Removing and
installing front underbody cladding.
– Move bumper carrier to service position ⇒ General body
repairs, exterior; Rep. gr. 63; Front bumper; Moving bumper
carrier to and back from service position.
CAUTION
Risk of injury as the radiator fan(s) may start up automatically.
– When working in the vicinity of the radiator, keep a safe
distance from the radiator fan.
– Do not reach into the radiator fan when unplugging the
electrical connector.
– Disconnect electrical connector of radiator fan -
VX57--arrow-.
94
Rep. gr.19 - Cooling
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
– ⇒ Rep. gr. 19; Draining coolant.
– Pull out securing clip -arrow-, and pull lower left coolant hose
-1- off radiator.
– Pull out securing clip -arrow-, and pull upper right coolant
hose off radiator.
– Disconnect refrigerant lines from condenser/gas cooler
⇒ Heating, air conditioning; Rep. gr. 87; Refrigerant circuit;
Disconnecting refrigerant lines from and connecting to con‐
denser/gas cooler.
– Pull out locking elements for bottom radiator mountings
-arrow- on left and right from retaining plates -1- and remove
retaining plates.
4. Radiator, radiator fan
95
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
Important
•
The aid of an additional mechanic is required for the subse‐
quent work steps.
– Lift out radiator module from radiator mountings.
Installing
Install in reverse order of removal, observing the following:
– Connect refrigerant lines to condenser/gas cooler ⇒ Heating,
air conditioning; Rep. gr. 87; Refrigerant circuit; Disconnect‐
ing refrigerant lines from and connecting to condenser/gas
cooler.
– Move bumper carrier back from service position ⇒ General
body repairs, exterior; Rep. gr. 63; Front bumper; Moving
bumper carrier to and back from service position.
Tightening torques
♦ ⇒ Rep. gr. 19; Assembly overview - radiator/radiator fan
4.4
Dismantling and assembling radiator
module
Dismantling radiator module
– Remove radiator module ⇒ Rep. gr. 19; Removing and in‐
stalling radiator module.
– Press in retaining tabs -1- for radiator cowl on both sides in
direction of -arrow A-.
96
Rep. gr.19 - Cooling
2024 VW ID.4 Owner's Manual
