ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
– Unscrew bolts -2- and -3-.
– Use workshop hoist to raise motor -1-.
♦ ⇒ Rep. gr. 10; Securing motor (front) to engine and gearbox
support
2.3
Securing motor (front) to engine and
gearbox support
Special tools and workshop equipment required
♦ Engine bracket -VAS 6095A/1-22-
♦ engine and gearbox support -VAS 6095A-
♦ engine bracket -VAS 6095A/1-22-
♦ lifting device -VAS 501 021-
♦ retaining plate -VW309A-
♦ workshop hoist -VAS 6100-
Three-phase current drive 2 -VX97- with power and control
electronics 2 for electric drive -JX4- are referred to as the motor
below.
– Insert bracket of lifting device -VAS 501 021- -A- in holes
-arrows B-.
– Screw bolt -1- hand-tight into hole -arrow C- as far as stop.
– Secure shackle -2- in centre hole.
– Attach workshop hoist -VAS 6100- to shackle -2- and raise
motor.
– Remove bolts -arrows- and detach motor support -1-.
2. Removing and installing front motor
23
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
– Fit engine bracket -VAS 6095A/1-22- -A- on motor -1- and
tighten bolts -arrows-.
– Insert retaining plate -VW309A- -B- in engine and gearbox
support -VAS 6095A- -C-.
– Fit engine bracket -VAS 6095A/1-22- -A- on retaining plate
-VW309A- -B- and tighten bolts -arrows-.
Tightening torques
Bolts
Tightening torque/angle speci‐
fication
Engine bracket -VAS 6095A/ 20 Nm
1-22- to motor
24
Rep. gr.10 - Removing and installing engine
ID.4 2021 ➤, ID.3 2020 ➤
Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220 - Edition 11.2021
Bolts
Tightening torque/angle speci‐
fication
Engine bracket -VAS 6095A/ 80 Nm
1-22- to retaining plate -
VW309A-
2.4
Installing front motor
2.4.1
Installing front motor, left-hand drive
vehicles
Special tools and workshop equipment required
♦ lifting tackle -VAS 501 021-
♦ workshop hoist -VAS 6100-
The three-phase current drive 2 -VX97- along with the power
and control electronics 2 for electric drive -JX4- will henceforth
be referred to as “motor”.
Installing
– Insert bracket of lifting tackle -VAS 501 021--A- into holes
-arrows B-.
– Screw bolt -1- to stop into hole -arrow C- by hand.
– Secure shackle -2- in centre hole.
– Attach workshop hoist -VAS 6100- to shackle -2-.
– Use workshop hoist to position motor -1- on subframe.
2. Removing and installing front motor
25
2024 VW ID.4 Owner's Manual
