ID.4 2021 ➤
Brake system - Edition 07.2021
❑ Renew after removing
❑ 50 Nm + 180°
19 - Drive shaft
❑ ⇒ Running gear, axles, steering; Rep. gr. 42; Drive shaft; Removing and installing drive shaft
3.2
Assembly overview – brake shoes
The overview is shown for the left side of the vehicle as an
example.
3. Rear brake
45
ID.4 2021 ➤
Brake system - Edition 07.2021
1 - Brake carrier
2 - Hold-down pin
3 - Sealing plug
4 - Bolt
❑ 10 Nm
5 - Protective cap for bleeder
screw
6 - Bleeder screw
❑ 10 Nm
7 - Pin
❑ For brake hose adjust‐
ment
8 - Bolt
❑ 8 Nm
9 - Bracket for parking brake
motor
10 - Left parking brake motor
-V282- / right parking brake
motor -V283-
❑ ⇒ Rep. gr. 46; Remov‐
ing and installing park‐
ing brake motor [V282]/
[V283]
11 - Lower support
12 - Brake shoe
❑ Check thickness of
brake linings ⇒ Mainte‐
nance; Booklet ; Front
and rear brake pads/
linings: Checking thick‐
ness
❑ Renew on both sides
❑ Wear limit ⇒ Rep. gr. 00; Technical data for brakes
❑ ⇒ Rep. gr. 46; Removing and installing brake shoes
13 - Retaining clip
❑ For locking brake shoe
❑ Qty. 2
14 - Lower return spring
15 - Upper return spring
16 - Automatic adjuster
❑ Left-side version with annular groove on coarse adjuster
❑ With adjustment screw
17 - Wheel brake cylinder
❑ ⇒ Rep. gr. 47; Checking wheel brake cylinder for leaks
18 - Brake shoe with lever for parking brake
❑ Check thickness of brake linings ⇒ Maintenance; Booklet ; Front and rear brake pads/linings: Check‐
ing thickness
❑ Renew on both sides
❑ Wear limit ⇒ Rep. gr. 00; Technical data for brakes
46
Rep. gr.46 - Brakes - mechanism
ID.4 2021 ➤
Brake system - Edition 07.2021
❑ ⇒ Rep. gr. 46; Removing and installing brake shoes
3.3
Removing and installing brake shoes
Special tools and workshop equipment required
♦ assembly tool -T30114-
♦ brake drum calliper gauge -VAS 6787-
♦ pliers -T10623-
WARNING
Health hazard due to poisonous dust from brake system.
Risk of irreversibly deposited dust particles in the lungs. Risk
of respiratory health problems.
– Never blow out the brake system with compressed air.
Removal and installation are described for the left side of the
vehicle as an example.
Important
•
Do not operate the brake when the system is open.
Removing
– Remove wheel bearing unit ⇒ Running gear, axles, steering;
Rep. gr. 42; Wheel bearing assembly, trailing arm; Remov‐
ing and installing wheel bearing unit .
– Use assembly tool -T30114- -2- to remove retaining clips -1-
in direction of -arrow- . Press against pin from behind while
doing so.
– Lever brake shoe with parking brake lever -1- in direction of
-arrow A- off lower support -2- with aid of water pump pliers
-4- .
3. Rear brake
47
2024 VW ID.4 Owner's Manual
