ID.4 2021 ➤
Brake system - Edition 07.2021
Stage
Nut
Specified tor‐
que/turning further
angle
3.
-5-
20 Nm
5.2
Separating brake pedal from brake ser‐
vo
Special tools and workshop equipment required
♦ Release tool -T10006A-
♦ release tool -T10006A-
Removing
– For reasons of clarity, the pedal cluster is not shown in the
illustrations of the following work procedures.
– First press brake pedal -1- in direction of brake servo, and
hold it in this position.
1 - Brake pedal
2 - Push bar
3 - Retaining lugs
4 - Mounting bracket
A - Release tool -T10006A-
– Insert release tool -T10006A- -A- , and pull it in direction of
front seat. When doing this, counterhold on brake pedal -1- .
At this stage, pedal must not be allowed to move towards
front seat. This action will press retaining lugs -3- of mount‐
ing off ball head of plunger rod -2- .
– Pull release tool -T10006A- -A- and brake pedal -1- together
towards front seat. When doing this, brake pedal -1- is pulled
off ball head of push rod -2- .
5.3
Connecting brake pedal to brake servo
– Hold ball head of push rod -2- in front of mounting -1-, and
push brake pedal in direction of -arrow- towards brake servo.
The ball head of the push rod must be heard to engage.
60
Rep. gr.46 - Brakes - mechanism
ID.4 2021 ➤
Brake system - Edition 07.2021
– Check engagement by pulling briefly on brake pedal.
5.4
Removing and installing brake pedal
5.4.1
Removing and installing brake pedal,
left-hand drive vehicles
Removing
– Remove lower steering column trim ⇒ General body repairs,
interior; Rep. gr. 68; Compartments/covers; Removing and
installing lower steering column trim
– Remove footwell vent on driver side ⇒ Heating, air condition‐
ing system; Rep. gr. 87; Air duct; Removing and installing
footwell vent on driver side .
– Remove crash bar ⇒ General body repairs, interior; Rep.
gr. 70; Central tube for dash panel; Removing and installing
crash bar .
– ⇒ Rep. gr. 46; Separate brake pedal from brake servo .
– Pull clamping washer -2- off pivot pin -1- .
– Pull out pivot pin -1- towards right in direction of -arrow- .
– Remove brake pedal from mounting bracket.
Installing
– Renew pivot pin and clamping washer.
Important
•
Do not lubricate or grease the pivot pin. The pivot pin must
remain dry.
– Slide pivot pin from right to left through mounting bracket
and brake pedal.
5. Brake pedal
61
2024 VW ID.4 Owner's Manual
