ID.4 2021 ➤
Brake system - Edition 07.2021
4
Parking brake
4.1
Assembly overview – parking brake
1 - Electromechanical parking
brake warning lamp -K213-
❑ In control unit with dis‐
play unit for driver infor‐
mation system -J1254-
2 - Electromechanical parking
brake button -E538-
❑ In steering column
switch module
❑ ⇒ Rep. gr. 94; Steer‐
ing column switch mod‐
ule; Removing and in‐
stalling steering column
switch module
3 - Brake servo -NX6-
❑ With brake servo con‐
trol unit -J539-
❑ With brake fluid level
warning contact -F34-
❑ With brake pedal posi‐
tion sender -G100-
❑ With brake pedal posi‐
tion sender 2 -G836-
4 - Right parking brake motor
-V283-
❑ On rear right brake
drum
❑ ⇒ Rep. gr. 46; Remov‐
ing and installing park‐
ing brake motor [V282]/
[V283]
5 - Bracket
6 - Bolt
❑ 8 Nm
7 - Left parking brake motor -V282-
❑ On rear left brake drum
❑ ⇒ Rep. gr. 46; Removing and installing parking brake motor [V282]/[V283]
8 - Bracket
9 - Control unit for electromechanical parking brake -J540-
❑ Integrated into ABS control unit -J104- and cannot be renewed individually
❑ ⇒ Rep. gr. 45; Removing and installing ABS control unit [J104]/ABS hydraulic unit [N55]
4.2
Removing and installing control unit for
electromechanical parking brake [J540]
The control unit for electromechanical parking brake -J540- is
integrated into the ABS control unit -J104- and cannot be re‐
newed individually.
4. Parking brake
55
ID.4 2021 ➤
Brake system - Edition 07.2021
– Removing and installing ABS control unit -J104- ⇒ Rep.
gr. 45; Removing and installing ABS control unit [J104]/ABS
hydraulic unit [N55] .
4.3
Removing and installing parking brake
motor [V282]/[V283]
Removing
The left parking brake motor -V282- and right parking brake
motor -V283- will henceforth be referred to as “parking brake
motor”.
Removal and installation are described for the left side of the
vehicle as an example.
Important
•
Switch off ignition for at least 30 seconds before disconnect‐
ing electrical connector.
– Remove brake shoes, and unhook parking brake cable from
brake shoe ⇒ Rep. gr. 46; Removing and installing brake
shoes .
– Disconnect electrical connector -2- from parking brake motor
-1- .
– Press down locking lug in bracket, and turn parking brake
motor out of bracket.
Installing
Install in reverse order of removal, observing the following:
– Carry out basic setting of brake system using ⇒ Vehicle
diagnostic tester .
Tightening torques
♦ ⇒ Rep. gr. 46; Assembly overview – rear brake, drum brake
♦ ⇒ Rep. gr. 46; Assembly overview – brake shoes
56
Rep. gr.46 - Brakes - mechanism
2024 VW ID.4 Owner's Manual
