ID.4 2021 ➤, ID.5 2021 ➤
Maintenance - Edition 11.2021
4.27
Motor compartment cover (noise insu‐
lation) “bottom”: removing and instal‐
ling
Procedure
⇒ General body repairs, exterior; Rep. gr. 66; Noise insulation;
Assembly overview - noise insulation
4.28
Road test: performing (driving behav‐
iour, noises, air conditioner etc.)
Which of the following can be checked depends on vehicle
equipment and local conditions (urban/country).
Check the following during a road test:
♦ Motor: performance, acceleration
♦ Automatic gearbox: Selector lever position, shift lock/ignition
key removal lock, shift behaviour, dash panel insert display
♦ Foot brake and handbrake: function, free travel and effec‐
tiveness, pulling to one side, juddering, squeal
♦ ABS function: pulsing must be felt at the brake pedal during
ABS-regulated braking
♦ Steering: function, steering free clearance, steering wheel
centred when vehicle is travelling straight ahead
♦ Radio/radio navigation system: function, reception, GALA,
interference noise
♦ Multi-function indicator (MFI): functions
♦ Air conditioning system: check function (At low temperatures
the function of air conditioner must be checked in a work‐
shop).
♦ Vehicle: pulls to one side when travelling straight ahead (lev‐
el road).
♦ Imbalance: wheels, drive shafts, propshaft
♦ Noise/vibration: wheel bearing, exhaust system
4.29
Wheel securing bolts: tightening to
specified torque
Special tools and workshop equipment required
♦ Adapter set for wheel bolts -T10313-
♦ Torque wrench
4. Descriptions of work
51
ID.4 2021 ➤, ID.5 2021 ➤
Maintenance - Edition 11.2021
Note
♦ To loosen/tighten the anti-theft wheel bolts a special adapt‐
er, located in vehicle tool kit, is required.
♦ To loosen the anti-theft wheel bolts (lockable wheel bolts) do
not use an impact screwdriver.
♦ If the adapter to loosen or tighten the anti-theft wheel bolts
is not available in the vehicle, use the corresponding adapter
set for tamper-proof wheel bolts.
– Fit adapter -2- onto anti-theft wheel bolt -1- as far as stop.
– Fit wheel brace onto adapter -2- as far as stop.
– Tighten wheel bolts diagonally to specified torque.
Specified torque
Wheel bolts
Nm
120
4.30
Tyre Pressure Loss Indicator: calibrat‐
ing
Note
♦ The calibration of the Tyre Pressure Loss Indicator must on‐
ly be performed “after” the tyre pressure has been corrected
to the prescribed values.
♦ If no pressure loss and tyre damage are found after a tyre
pressure warning, the incorrect warning can be rectified by
calibrating.
Tyre Pressure Loss Indicator compares the speed and thus
the rolling circumference and vibrations of the individual wheels
via the ABS sensors. If the tyre pressure changes on one or
several wheels, the Tyre Pressure Loss Indicator will indicate
this in the dash panel insert and the Infotainment system.
The rolling circumference of tyre changes if:
♦ The tyre pressure is too low.
♦ The tyre has structural damage.
♦ The vehicle is loaded more heavily on one side.
52
4. Descriptions of work
2024 VW ID.4 Owner's Manual
