1. Tap the
2. Tap the
control for parking functions in the upper section of the center console.
function key.
3. Select a setting, e.g. automatic activation when driving forward or maneuver braking.
Driving with a trailer
If a trailer electrical system is connected, the rear and side sensors of the Park Distance Control are not switched on:
You are not warned about obstacles.
The maneuver braking is also deactivated automatically.
Switching Park Distance Control (PDC) on and off
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety instructions.
Switching on
1. Select the reverse gear.
Or: tap the
control in the upper section of the center console. Then tap the
function key in the Infotainment system, if necessary.
Or: The vehicle will roll backward.
Switching off
1. Tap the
function key.
Or: the vehicle is driving forward at more than approx. 10 km/h (approx. 6 mph) up to approx. 15 km/h (approx. 9 mph).
Or: tap the control in the upper section of the center console.
Or: the electronic parking brake is switched on.
Automatic activation when driving forward
If the vehicle slowly approaches an obstacle, Park Distance Control is automatically activated.
1. Tap the
control in the upper section of the center console.
2. Switch the function on or off.
If the driver switches off Park Distance Control, no further automatic activation occurs.
Automatic activation is available again under following conditions:
The vehicle has been accelerated to more than approx. 15 km/h (approx. 9 mph) and then the speed has fallen below this again.
Or: the ignition has been switched off and on again.
If an obstacle is detected in front of the vehicle, the display in the Infotainment system is activated. If the vehicle approaches further, warning chimes also
sound.
Rear View Camera (Rear View)
Introduction
The Rear View Camera system in the
rear of the vehicle makes it easier for
the driver to see behind the vehicle and
assists when parking.
System function
The Rear View Camera system shows the area behind the vehicle on the Infotainment system screen. Depending on the mode and vehicle equipment, orientation
lines may assist in the view toward the rear ⇒
.
WARNING
The Rear View Camera system is not a replacement for the driver's attention and works only within the system limitations. Using the camera image to estimate
the distance to people or obstacles may not be precise. If you do not take care, there is a risk of accidents and serious injuries.
Always stay attentive and do not rely solely on the system. The driver is always responsible for control of the vehicle.
Bear in mind that camera lenses can enlarge and distort the field of vision.
The orientation lines superimposed on the camera image are shown by the system regardless of the vehicle's surroundings. There is no automatic obstacle
detection by the camera while it is active. The driver must evaluate whether the vehicle will fit in the parking space.
If a trailer is connected to the factory-installed trailer hitch, all orientation lines for the rear area are hidden in the camera image.
If a camera is installed in the trunk lid, the orientation lines are also hidden if the trunk lid is open.
167
Switching the Rear View Camera system on and off
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety instructions.
Switching on
1. Select the reverse gear.
Or: tap the
control in the upper section of the center console. If available, then tap the
function key in the Infotainment system.
Switching off
1. The vehicle drives at more than approx. 15 km/h (approx. 9 mph).
Or: Tap the or function key on the screen of the Infotainment system.
Parking (Rear View Camera system with parking mode selection)
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety instructions.
Screen display
Perpendicular parking: Guide lines help when parking in reverse perpendicular to the road.
Cross traffic: Depiction of the area behind the vehicle and the
areas to the side of the vehicle at a wide angle.
Red line: Boundary or safety distance from the vehicle.
Adjust the brightness, contrast, and color.
Yellow lines: the vehicle's path based on the
steering angle. Green horizontal lines: Boundaries.
USA and Canada: If the camera image on a parking system has been switched on by engaging the reverse gear, no function keys are displayed for safety reasons.
These function keys can be displayed again by tapping the function key
.
Parking mode: Parking perpendicular to the road
Fig. 100 Infotainment system: Parking perpendicular to the road.
Searching for a parking space.
Steering toward the selected parking space.
Aligning the vehicle within the parking space.
Road surface.
Parking space.
Side boundary of the parking space.
Rear boundary of the parking space.
1. Press the
necessary.
control panel for parking functions before driving past the selected parking space. Then tap the
function key in the Infotainment system, if
168
2. To select the parking mode, tap the
3. Position your vehicle in front of the parking space fig. 100
4. Steer so that the yellow lines lead into the parking space. The green and yellow lines must align with the side boundary lines
function key in the Infotainment system.
.
fig. 100
.
5. Stop when the red line reaches the rear boundary fig. 100
.
Area View
Introduction
Area View provides an overview of the
entire vehicle environment in real time.
This function helps you recognize
obstacles in good time in situations
where there might be blind spots.
System function
Area View has several cameras, e.g. Rear View Camera system, front camera, and cameras in the outside mirrors, to show the vehicle environment on the
Infotainment system screen ⇒
.
The functions and displays of Area View may vary depending on the vehicle equipment, e.g. if Park Distance Control is available and is also displayed.
WARNING
Area View is not a replacement for the driver's attention and works only within the system limitations. Using the camera image to estimate the distance to people
or obstacles may not be precise. If you do not take care, there is a risk of accidents and serious injuries.
Always stay attentive and do not rely solely on the system. The driver is always responsible for control of the vehicle.
Bear in mind that camera lenses can enlarge and distort the field of vision.
Switching on and off
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety instructions.
Switching on
1. Select the reverse gear.
Or: tap the
control in the upper section of the center console. Then tap the
function key on the Infotainment system screen.
Switching off
1. Drive faster than approx. 15 km/h (approx. 9 mph).
Or: Tap the
Or: tap the
or
function key on the screen of the Infotainment system.
control for parking functions.
Changing the camera perspective
Please read the introductory information and heed the Warnings and Notice ⇒
and Safety instructions.
Fig. 101 Infotainment system: Area View in the "Front angled parking" mode (general example).
Bird's eye view with selectable sections of the screen.
Camera image.
Area for the function keys of Area View.
169
2024 VW ID.4 Owner's Manual
