5. Adjust the head restraint to the correct position.
Seat functions
Center armrest
Front center armrest
Fig. 67 Front center armrest.
To lift: Pull the center armrest up in the direction of the arrow fig. 67.
To lower: Pull the center armrest up fully. Then press the center armrest down.
Depending on vehicle equipment, there may be a storage compartment located under the center armrest.
WARNING
If the front center armrest is opened all the way or not completely closed, it can limit the driver’s ability to move his or her arms, which can cause accidents and
serious injuries.
Always keep the storage compartments closed while driving.
Never allow an adult or child to ride on the center armrest. This incorrect seating position can cause serious injuries.
Rear center armrest
Fig. 68 Folding center armrest in the rear (general example).
There may be a folding armrest in the backrest of the rear center seat.
To fold forward: pull the center armrest in the direction of the arrow using the loop fig. 68.
To fold back: fold the center armrest upward in the opposite direction of the arrow fig. 68 and press it all the way toward the seat backrest.
Passengers must not sit in the center rear seat when the center armrest is folded down.
91
WARNING
Incorrect use of the rear center armrest may cause serious injuries.
The rear center armrest must always be folded up during journeys.
If the center armrest is folded down, the center rear bench seat must never be used by either adults or children.
Never allow an adult or child to ride on the center armrest.
Memory function
Memory buttons
Fig. 69 On the outer side of the driver’s seat: memory buttons.
Driver seat and outside mirror settings can be saved and called up using the memory buttons.
Storing the driver's seat and outside mirror settings for driving forward
1. Set the electronic parking brake.
2. Shift the transmission to neutral.
3. Switch the ignition on.
4. Adjust the driver's seat and outside mirror.
5. Press and hold the
fig. 69 button for longer than one second.
6. Press the desired memory button within approximately ten seconds.
A chime will confirm that the settings were saved.
Storing the front passenger's outside mirror settings for driving in reverse
1. Set the electronic parking brake.
2. Shift the transmission to neutral.
3. Switch the ignition on.
4. Press the desired memory button fig. 69.
5. Select the reverse gear.
6. Adjust the front passenger's outside mirror so that the edge of the curb can be seen clearly, for example.
The selected mirror position will be stored automatically and assigned to the vehicle key that was used to unlock the vehicle.
Recalling driver's seat and outside mirror settings
1. When the vehicle is stationary, the ignition is switched off, and a door is open, press the respective memory button briefly.
After approximately ten minutes, the stored positions can no longer be adjusted automatically. The adjustment process will be canceled if one of the memory
buttons is pressed again.
Or: When the ignition is switched on or the door is closed, press and hold the respective memory button until the saved positions are reached.
The front passenger's outside mirror automatically leaves the position stored for driving in reverse once you begin driving forward at speeds of at least approx.
15 km/h (approx. 10 mph) or when you turn the knob for the outside mirrors from the R position to another position.
If you open the driver door more than approximately ten minutes after the vehicle is unlocked, the driver seat and the outside mirrors will not be adjusted
automatically.
Front seat convenience entry function
Variant 1: When the driver door is opened, the driver seat moves automatically to a position that makes it easy to enter the vehicle. The driver seat automatically
returns to its original position once you have closed the driver door and switched on the ignition.
92
Version 2: Before the vehicle is exited, the driver seat moves automatically to the rear position and remains there. After the vehicle is re-entered and the driver door
is closed, the driver seat moves forwards to the last saved position.
The front seat convenience entry function can be enabled and disabled in the Infotainment system.
WARNING
Improper use of seat functions can cause injuries.
Before beginning a journey always adjust to the correct seat position and maintain this throughout the journey. This also applies to all passengers.
Set the memory function only with the vehicle stationary.
Always keep your hands, fingers, feet and other parts of your body clear of the area in which the seats operate and move during adjustment.
1) Only if personalization has been activated.
Massage feature
Fig. 70 Massage function button to the side of the driver seat.
For the massage function, the lumbar support moves and massages the lumbar area of your back.
The lumbar support cushioning (intensity of the massage) can be individually adjusted in three stages during operation by pressing repeatedly on the corresponding
switch ⇒ Adjusting power front seats.
Switching the massage function on and off
1. To switch on, push the
button in the seat control panel. Press the
button again to switch off.
After around ten minutes, the massage function switches off automatically.
WARNING
Improper use of seat functions can cause injuries.
Before beginning a journey always adjust to the correct seat position and maintain this throughout the journey. This also applies to all passengers.
Only switch the massage function on and off when the vehicle is stationary.
Always keep your hands, fingers, feet and other parts of your body clear of the range of operation and adjustment range of the seats.
93
2024 VW ID.4 Owner's Manual
