Table of Contents > 3 Refrigerant circuit > 3.25 Removing and installing heat condenser, R744

VW ID.4 Heating & Air Conditioning System ➜ 3.25 Removing and installing heat condenser, R744

ID.4 2021 ➤  
Heating, air conditioning system - Edition 09.2021  
Tightening torques  
♦ ⇒ Rep. gr. 87; Assembly overview – valve unit of heat pump  
♦ ⇒ Rep. gr. 87; Assembly overview – refrigerant lines  
3.25  
Removing and installing heat condens‐  
er, R744  
3.25.1  
Removing and installing heat condens‐  
er  
– Heat condenser -11- is currently not available separately  
⇒ Electronic parts catalogue (ETKA).  
3.26  
Removing and installing refrigerant  
shut-off valve for heater and air condi‐  
tioner unit [N541]  
3.26.1  
Removing and installing refrigerant  
shut-off valve for heater and air condi‐  
tioner unit [N541], left-hand drive vehi‐  
cles  
Special tools and workshop equipment required  
♦ engine bung set -VAS 6122-  
Removing  
Immediately seal any open lines and connections with clean  
plugs from engine bung set -VAS 6122-.  
– Remove air intake unit of heater and air conditioning unit  
⇒ Rep. gr. 87; Removing and installing air intake unit of  
heater and air conditioning unit.  
– ⇒ Air conditioning systems with refrigerant R1234yf – Gener‐  
al notes; Rep. gr. 87; Working with air conditioner service  
station; Draining air conditioner service station.  
– Disconnect electrical connector -4-.  
50  
Rep. gr.87 - Air conditioning system  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!