ID.4 2021 ➤
Heating, air conditioning system - Edition 09.2021
– Route electrical wire so that it cannot come into contact with
any moving parts (e.g. actuating arm on control motor).
If control motor has been renewed or installed at different posi‐
tion:
– Carry out function “Adapt flap limit stops of control mo‐
tors”⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Access to
diagnoses.
Tightening torques
♦ ⇒ Rep. gr. 87; Assembly overview – front control motors
♦ ⇒ Rep. gr. 87; Assembly overview – air duct and air distribu‐
tion in passenger compartment
6.9
Removing and installing control motor
for rear temperature flap [VX95]
Removing
The rear temperature flap -VX95- with rear temperature flap
control motor -V137- and potentiometer for rear temperature
flap control motor -G479- will henceforth be referred to as con‐
trol motor.
Mark position of control motors and connectors prior to removal
to avoid interchanging control motors at reinstallation.
– Deactivate function “Stationary air conditioning” ⇒ Owner’s
manual.
– Remove tunnel support cover ⇒ General body repairs, interi‐
or; Rep. gr. 70; Dash panel; Removing and installing tunnel
support cover.
– Disconnect electrical connector -4-.
– Unscrew bolts -1- and -3-.
– Remove control motor -2-.
6. Control motors
125
ID.4 2021 ➤
Heating, air conditioning system - Edition 09.2021
Installing
Install in reverse order of removal, observing the following:
– Check shaft -A- and mounting -B- of control motor -C-. They
should be correctly aligned so that they can be joined to‐
gether.
– Route electrical wire so that it cannot come into contact with
any moving parts (e.g. actuating arm on control motor).
If control motor has been renewed or installed at different posi‐
tion:
– Carry out function “Adapt flap limit stops of control mo‐
tors”⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Access to
diagnoses.
Tightening torques
♦ ⇒ Rep. gr. 87; Assembly overview – front control motors
♦ ⇒ General body repairs, interior; Rep. gr. 70; Dash panel;
Assembly overview – dash panel
6.10
Removing and installing control motor
for fresh air and air recirculation flap
[VX96]
Removing
The fresh air and air recirculation flap -VX96- with fresh air/air
recirculation, air flow flap -V425- and potentiometer for fresh
air/air recirculation, air flow flap control motor -G644- will hence‐
forth be referred to as control motor.
Mark position of control motors and connectors prior to removal
to avoid interchanging control motors at reinstallation.
– Deactivate function “Stationary air conditioning” ⇒ Owner’s
manual.
– Remove air intake unit of heater and air conditioning unit
⇒ Rep. gr. 87; Removing and installing air intake unit of
heater and air conditioning unit.
– Unscrew bolts -2-.
126
Rep. gr.87 - Air conditioning system
2024 VW ID.4 Owner's Manual
