Table of Contents > 5 Air conditioner compressor > 5.2 Removing refrigerant lines from and installing to air conditioner compressor, R1234yf

VW ID.4 Heating & Air Conditioning System ➜ 5.2 Removing refrigerant lines from and installing to air conditioner compressor, R1234yf

ID.4 2021 ➤  
Heating, air conditioning system - Edition 09.2021  
5.2  
Removing refrigerant lines from and in‐  
stalling to air conditioner compressor,  
R1234yf  
5.2.1  
Detaching and attaching refrigerant  
lines at air conditioner compressor  
Special tools and workshop equipment required  
♦ engine bung set -VAS 6122-  
Removing  
Seal off open pipes/lines and connections immediately with  
clean plugs from engine bung set -VAS 6122-.  
– ⇒ Air conditioners with refrigerant R1234yf - General infor‐  
mation; Rep. gr. 87; Working with the air conditioner service  
station; Discharging refrigerant circuit.  
– Remove air intake box of heater and air conditioning unit  
⇒ Rep. gr. 87; Removing and installing air intake box of  
heater and air conditioning unit.  
CAUTION  
Risk of frostbite from escaping pressurised refrigerant  
Risk of frostbite on skin and other parts of the body  
– Put on protective gloves.  
– Put on safety goggles.  
– Extract/drain refrigerant and then immediately open up re‐  
frigerant circuit.  
– Extract/drain refrigerant again if more than 10 minutes  
have passed since initial extraction and refrigerant circuit  
has not been opened up. Renewed evaporation has cre‐  
ated pressure in the refrigerant circuit.  
– Remove bolts -3- and detach refrigerant lines -2-.  
Installing  
Installation is carried out in reverse order; note the following:  
– Connect refrigerant lines -2- and tighten bolts -3-.  
5. Air conditioner compressor  
97  
ID.4 2021 ➤  
Heating, air conditioning system - Edition 09.2021  
– ⇒ Air conditioners with refrigerant R1234yf - General infor‐  
mation; Rep. gr. 87; Working with the air conditioner service  
station; Charging refrigerant circuit  
Tightening torques  
♦ ⇒ Rep. gr. 87; Exploded view - refrigerant lines  
5.3  
Detaching/attaching refrigerant lines  
from/to air conditioner compressor,  
R744  
5.3.1  
Detaching and attaching refrigerant  
lines at air conditioner compressor  
Special tools and workshop equipment required  
♦ engine bung set -VAS 6122-  
Removing  
Seal off open pipes/lines and connections immediately with  
clean plugs from engine bung set -VAS 6122-.  
– Perform function “Opening electrically actuated valves in re‐  
frigerant circuit for extracting, evacuating and charging” with  
⇒ Vehicle diagnostic tester ⇒ Rep. gr. 00; Starting diagnosis.  
– ⇒ Air conditioners with refrigerant R744 - General informa‐  
tion; Rep. gr. 87; Working with the air conditioner service  
station; Discharging refrigerant circuit.  
– Remove air intake box of heater and air conditioning unit  
⇒ Rep. gr. 87; Removing and installing air intake box of  
heater and air conditioning unit.  
CAUTION  
Risk of frostbite from escaping pressurised refrigerant  
Risk of frostbite on skin and other parts of the body  
– Put on protective gloves.  
– Put on safety goggles.  
– Extract/drain refrigerant and then immediately open up re‐  
frigerant circuit.  
– Extract/drain refrigerant again if more than 10 minutes  
have passed since initial extraction and refrigerant circuit  
has not been opened up. Renewed evaporation has cre‐  
ated pressure in the refrigerant circuit.  
– Remove bolts -3- and detach refrigerant lines -2-.  
98  
Rep. gr.87 - Air conditioning system  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!