ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
– Push sunroof roller blind -1- with attached Bowden cables
-4- in direction of -arrow A- into slotted guide -5-.
Continue installation in reverse order of removal, observing the
following:
Tightening torques
♦ ⇒ Rep. gr. 60; Assembly overview – sunroof roller blind
2.8
Adapting sliding sunroof adjustment
control unit [J245]
Important
•
Ignition is switched on.
– Press and hold “Close” button until adaption process is con‐
cluded (approx. 20 seconds).
The sunroof roller blind is completely closed.
Adaption can only be carried out using ⇒ Vehicle diagnostic
tester.
2.9
Removing and installing sunroof roller
blind motor [V260]
The sunroof roller blind motor -V260- will henceforth be referred
to as “sunroof roller blind motor”.
Removing
– Lower the moulded headliner, and place it onto head re‐
straints ⇒ General body repairs, interior; Rep. gr. 70; Roof
trims; Removing and installing moulded headliner.
– Switch off ignition and electrical consumers.
– Place vehicle key and other entry and start authorisation
devices (e.g. smartphone) outside the vehicle interior.
– Disconnect electrical connector -2-.
142
Rep. gr.60 - Sunroof
2024 VW ID.4 Owner's Manual
