ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
– Unscrew bolts -3-, and pull off sunroof roller blind motor -1-.
– Disconnect electrical connector -4- for sunroof roller blind
motor -1-.
Installing
Install in reverse order of removal, observing the following:
– Align sunroof roller blind motor parallel before installing.
– Connect electrical connector -3- for sunroof roller blind motor
-1-.
– Make sure that clip -2- is correctly seated -arrows A-.
– Switch on ignition.
Tightening torques
♦ ⇒ Rep. gr. 60; Assembly overview – sunroof roller blind
2.10
Removing and installing sunroof roller
blind cables
Removing
Note position of cables before removal to avoid errors during
installation.
– Remove sunroof roller blind ⇒ Rep. gr. 60; Removing and
installing sunroof roller blind.
– Pull cables -2- together with followers -3- in direction of
-arrows- out of side slotted guides -1-.
2. Sliding sunroof
143
ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
Installing
Install in reverse order of removal, observing the following:
Once the sunroof roller blind motor -V260- or the sunroof sun
blind has been renewed, the sliding sunroof adjustment control
unit -J245- must be adapted ⇒ Rep. gr. 60; Adapting sliding
sunroof adjustment control unit [J245].
Closing force limitation is deactivated during the adaption proc‐
ess.
2.11
Manual operation
If the electrical system fails to operate, the sunroof roller blind
motor -V260- can be manually operated with the aid of a com‐
mercially available hexagon key.
Considerable force will have to be applied when turning, since
the sunroof roller blind motor -V260- is not decoupled from the
drive unit.
Important
•
Moulded headliner is lowered and put on head restraints
⇒ General body repairs, interior; Rep. gr. 70; Roof trims;
Removing and installing moulded headliner.
– Insert commercially available hexagon key into bolt -2- of
sunroof roller blind motor -V260--1-.
– Turn bolt -2- to move sunroof roller blind.
144
Rep. gr.60 - Sunroof
2024 VW ID.4 Owner's Manual
