ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
2)
Observe minimum drying time ⇒ Rep. gr. 64; Minimum drying
time for bonded windows.
3)
Use double cartridge gun -VAS 5237- for processing.
4)
Cutting cords stated above can be used alternatively to the
cutting wires, and vice versa, and are designated for single use.
2.4
Preparing old undamaged windows for
installing
Special tools and workshop equipment required
♦ contour blade set -VAS 852 005-
♦ scraper set -VAS 861 005-
Note
Glazing without centring pins can be installed. The centring pins
are only relevant for production.
Note
If required, the glazing can be fixed in place with adhesive tape
during the minimum drying time.
– If an undamaged window -4- is reused, use a suitable scra‐
per -1- from contour blade set -VAS 852 005- or scraper set
-VAS 861 005- to cut back remaining adhesive sealant -2- to
1 to 2 mm shortly before bonding window back in.
Note
If an undamaged window is reused, the remaining adhesive
sealant serves as the adhesion base for the new adhesive seal‐
ant to be applied.
Note
Do not damage primer and ceramic coating when cutting back
adhesive sealant.
Note
Keep bonding surface free of dirt and grease.
Note
Do not treat adhesive bead that has just been cut back with
activator, glass/paint primer or cleaning solution.
Note
If bonding is performed later than one day after cutting back
the adhesive bead, the remaining adhesive sealant must be
activated with activator.
2. Repair notes
179
ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
NOTICE
Risk of damage to paint caused by activator.
– Apply activator precisely onto adhesive bead that has been
cut back, and do not spill any activator.
– Use applicator to apply activator evenly in one pass onto
adhesive bead that has been cut back.
Note
The drying time is approx. 10 minutes.
2.5
Preparing new windows for installing
Note
The application area for the adhesive bead is not precoated or
primed.
Note
The sealing lip is included with a new windscreen.
Note
No windows are precoated.
Note
The ceramic layer is not a primer.
– Use cleaning solution to clean edge of window all round to a
width of 20 mm.
– Rub edge of window dry using a lint-free cloth.
– Use applicator -2- to apply primer-3- evenly in one pass.
Note
The drying time is approx. 10 minutes.
2.6
Preparing body flange for installing
Special tools and workshop equipment required
♦ scraper set -VAS 861 005-
180
Rep. gr.64 - Glazing
2024 VW ID.4 Owner's Manual
