Table of Contents > Exterior equipment > 6 Removing and installing Roof moulding and roof railing

VW ID.4 Body Repairs Exterior ➜ 6 Removing and installing Roof moulding and roof railing

ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
6
Roof moulding and roof railing  
6.1  
Assembly overview – roof railing  
1 - Roof railing  
❑ ⇒ Rep. gr. 66; Remov‐  
ing and installing roof  
railing  
2 - Nut  
❑ qty. 8  
❑ 9 Nm  
6.2  
Assembly overview – roof trim strip  
The overview is shown for the left side of vehicle as an exam‐  
ple.  
6. Roof moulding and roof railing  
247  
ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
1 - Roof trim strip  
❑ ⇒ Rep. gr. 66; Remov‐  
ing and installing roof  
trim strip  
2 - Clip  
❑ qty. 13  
3 - Clip  
❑ Part of roof trim strip  
4 - C-pillar trim  
❑ ⇒ Rep. gr. 66; Remov‐  
ing and installing C-pil‐  
lar trim  
5 - Adhesive tape  
❑ Part of C-pillar trim  
6 - End cap  
6.3  
Removing and installing roof railing  
Removing  
– Remove moulded headliner ⇒ General body repairs, interior;  
Rep. gr. 70; Roof trims; Removing and installing moulded  
headliner.  
– Unscrew nuts -2-.  
248  
Rep. gr.66 - Exterior equipment  
ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Remove roof railing -1- in direction of -arrow A-.  
Installing  
Install in reverse order of removal, observing the following:  
Important  
Make sure that the seals make even contact and are not  
damaged.  
Tightening torques  
♦ ⇒ Rep. gr. 66; Assembly overview – roof railing  
6.4  
Removing and installing roof trim strip  
Removal and installation are described for the left side of vehi‐  
cle as an example.  
Removing  
– Remove C-pillar trim ⇒ Rep. gr. 66; Removing and installing  
C-pillar trim.  
– Use commercially available wedge -5- to lever clip -4- in  
direction of -arrow- off roof side member -3-.  
6. Roof moulding and roof railing  
249  
ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Use commercially available wedge -5- to lever roof trim strip  
-1- in direction of -arrow- from rear towards front off clips -2-.  
Installing  
Important  
If clip -4- on roof trim strip -1- is damaged, the roof trim strip  
-1- must be renewed.  
– Guide in roof trim strip -1- behind wing -5-.  
– Align roof trim strip -1- with roof side member -3-.  
– Fit roof trim strip -1- with clip -4- in direction of -arrow A-.  
– Starting at -arrow A- up to -arrow C- push on roof trim strip  
-1- at clips -2- until they can be heard to engage.  
Continue installation in reverse order of removal.  
250  
Rep. gr.66 - Exterior equipment  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!