Table of Contents > Sunroof > Removing and installing sunroof roller blind motor [V260]

VW ID.4 Body Repairs Exterior ➜ Removing and installing sunroof roller blind motor [V260]

ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Push sunroof roller blind -1- with attached Bowden cables  
-4- in direction of -arrow A- into slotted guide -5-.  
Continue installation in reverse order of removal, observing the  
following:  
Tightening torques  
♦ ⇒ Rep. gr. 60; Assembly overview – sunroof roller blind  
2.8  
Adapting sliding sunroof adjustment  
control unit [J245]  
Important  
Ignition is switched on.  
– Press and hold “Close” button until adaption process is con‐  
cluded (approx. 20 seconds).  
The sunroof roller blind is completely closed.  
Adaption can only be carried out using ⇒ Vehicle diagnostic  
tester.  
2.9  
Removing and installing sunroof roller  
blind motor [V260]  
The sunroof roller blind motor -V260- will henceforth be referred  
to as “sunroof roller blind motor”.  
Removing  
– Lower the moulded headliner, and place it onto head re‐  
straints ⇒ General body repairs, interior; Rep. gr. 70; Roof  
trims; Removing and installing moulded headliner.  
– Switch off ignition and electrical consumers.  
– Place vehicle key and other entry and start authorisation  
devices (e.g. smartphone) outside the vehicle interior.  
– Disconnect electrical connector -2-.  
142  
Rep. gr.60 - Sunroof  
ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Unscrew bolts -3-, and pull off sunroof roller blind motor -1-.  
– Disconnect electrical connector -4- for sunroof roller blind  
motor -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– Align sunroof roller blind motor parallel before installing.  
– Connect electrical connector -3- for sunroof roller blind motor  
-1-.  
– Make sure that clip -2- is correctly seated -arrows A-.  
– Switch on ignition.  
Tightening torques  
♦ ⇒ Rep. gr. 60; Assembly overview – sunroof roller blind  
2.10  
Removing and installing sunroof roller  
blind cables  
Removing  
Note position of cables before removal to avoid errors during  
installation.  
– Remove sunroof roller blind ⇒ Rep. gr. 60; Removing and  
installing sunroof roller blind.  
– Pull cables -2- together with followers -3- in direction of  
-arrows- out of side slotted guides -1-.  
2. Sliding sunroof  
143  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!