ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
2.3
Assembly overview – sunroof roller blind
2. Sliding sunroof
131
ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
1 - Cross piece for slotted
guide
❑ ⇒ Rep. gr. 60; Remov‐
ing and installing slot‐
ted guide
2 - Nut
❑ qty. 13
❑ Renew after removing
❑ 8 Nm
3 - Side slotted guide
❑ Left and right
❑ ⇒ Rep. gr. 60; Remov‐
ing and installing slot‐
ted guide
4 - Clip
❑ qty. 7
5 - Bowden cable guide
❑ Left and right
6 - Spring plate
7 - Sunroof roller blind motor
-V260-
❑ With sunroof roller
blind motor Hall send‐
er -G404-, Hall send‐
er 2 for sunroof roll‐
er blind motor -G917-,
Hall sender for rear
sunroof roller blind mo‐
tor -G919- und Hall
sender 2 for rear sun‐
roof roller blind motor -
G920-
❑ ⇒ Rep. gr. 60; Remov‐
ing and installing sunroof roller blind motor [V260]
8 - Bolt
❑ qty. 3
❑ 4 Nm
9 - Bolt
❑ qty. 4
❑ Renew after removing
❑ 5.5 Nm
10 - Sunroof roller blind
❑ ⇒ Rep. gr. 60; Removing and installing sunroof roller blind
11 - Electrical wire
12 - Sliding sunroof adjustment control unit -J245-
❑ ⇒ Rep. gr. 60; Removing and installing sliding sunroof adjustment control unit [J245]
❑ ⇒ Rep. gr. 60; Adapting sliding sunroof adjustment control unit [J245]
13 - Front part of slotted guide
❑ ⇒ Rep. gr. 60; Removing and installing slotted guide
14 - Bolt
❑ qty. 4
132
Rep. gr.60 - Sunroof
ID.4 2021 ➤
General body repairs, exterior - Edition 05.2021
❑ Renew after removing
❑ 5.5 Nm
15 - Bolt
❑ qty. 2
❑ Renew after removing
❑ 5.5 Nm
16 - Slide
2.4
Removing and installing glass panel
2.4.1
Removing soiling caused by adhesive
sealant
When cleaning the vehicle interior, newly inserted glass panel
must not be pushed outwards.
– Clean painted surface as well as possible using a dry clean‐
ing cloth.
– Use adhesive remover to remove any remaining soiling from
painted surface.
– Allow adhesive sealant on plastic trims to cure for approx.
1 hour, then pull it off.
2.4.2
Touching up paint damage
Important
•
If the paint is damaged, the paintwork structure must be re‐
stored according to specifications in the “Paintwork” manual.
2.4.3
Materials
Refer to ⇒ Electronic parts catalogue (ETKA) for current materi‐
al numbers.
1 2 3
♦ 2-component window adhe‐
sive
, ,
1
1
1
♦ Activator
♦ Primer
♦ Cleaning solution
♦ Applicator
1
4
4
♦ Adhesive remover
♦ Cutting cord -VAS 6888/1-
♦ Wire for cut‐
ting device -
VAS 6452/2-
4
♦ Cutting cord -
VAS 861
001/1A-
1
Observe manufacturer's instructions enclosed in the packag‐
ing.
2. Sliding sunroof
133
2024 VW ID.4 Owner's Manual
