Table of Contents > Front doors, door components, central locking > Central locking > Removing and installing actuator for high-voltage charging flap lock 1 [F498]

VW ID.4 Body Repairs Exterior ➜ Removing and installing actuator for high-voltage charging flap lock 1 [F498]

ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Disengage hook -3- in direction of -arrow A-.  
– Push door control unit -1- in direction of -arrow B-, and re‐  
move it.  
Installing  
Install in reverse order of removal, observing the following:  
– Use ⇒ Vehicle diagnostic tester to code new door control  
unit.  
– Read and clear event memory using ⇒ Vehicle diagnostic  
tester.  
4.4  
Removing and installing ignition key  
battery  
See the ⇒ owner's manual for information about removal and  
installation of the battery in the ignition key.  
4.5  
Removing and installing actuator for  
high-voltage charging flap lock 1  
[F498]  
Removing  
– Remove charging flap unit ⇒ Rep. gr. 55; Removing and  
installing charging flap unit.  
– Disconnect electrical connector -3-.  
98  
Rep. gr.57 - Front doors, door components, central locking  
ID.4 2021 ➤  
General body repairs, exterior - Edition 05.2021  
– Unscrew bolts -2-.  
– Remove actuator for high-voltage charging flap lock 1 -  
F496--1- from charging flap unit.  
Installing  
Install in reverse order of removal, observing the following:  
Tightening torques  
♦ ⇒ Rep. gr. 55; Assembly overview – charging flap unit  
4. Central locking  
99  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!