ID.4 2021 ➤
Electrical system - Edition 02.2021
– Fold up cap -2- in direction of -arrow B-, and remove it.
– Loosen nut -3- a few turns.
– Fit puller -T10369/5--A- on wiper arm -2-.
– Position thrust piece -4- on wiper motor shaft.
– Turn spindle -1- clockwise until wiper arm -2- is pulled off
wiper motor shaft.
– Remove puller -T10369/5--A- from wiper arm -2-.
– Unscrew nut -3-.
– Remove wiper arm -2-.
Installing
Install in reverse order of removal, observing the following:
– ⇒ Rep. gr. 92; Adjust wiper arm.
Tightening torques
♦ ⇒ Rep. gr. 92; Assembly overview – rear window wiper sys‐
tem
4.4
Adjusting wiper arm
Procedure
– Loosen wiper arm ⇒ Rep. gr. 92; Removing and installing
wiper arm.
Distance -a- from end of wiper blade to bottom edge of rear
window must be 31 +/-5 mm.
– Adjust wiper blade park position by repositioning wiper arm
-1-.
4. Rear window wiper system
47
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Tighten nut of wiper arm -1-.
– Switch on ignition.
– Actuate “rear window wipe” function and allow wiper arm to
move to its end position.
– Check adjustment of wiper arm.
Tightening torques
♦ ⇒ Rep. gr. 92; Assembly overview – rear window wiper sys‐
tem
4.5
Removing and installing rear window
wiper motor [V12]
The rear window wiper motor -V12- will henceforth be referred
to as “rear window wiper motor”.
Removing
– Remove wiper arm ⇒ Rep. gr. 92; Removing and installing
wiper arm.
– Remove lower rear lid trim ⇒ General body repairs, interior;
Rep. gr. 70; Luggage compartment trims; Removing and
installing lower rear lid trim.
– Disconnect electrical connector -1-.
– Release retaining clips -2- counterclockwise.
– Remove rear window wiper motor -3-.
Installing
Install in reverse order of removal, observing the following:
– Moisten inside of seal in rear window with lubricant ⇒ Elec‐
tronic parts catalogue (ETKA).
48
Rep. gr.92 - Windscreen wash/wipe system
2024 VW ID.4 Owner's Manual
