Table of Contents > Controls > Removing and installing rear lid closure button [E574]

VW ID.4 Electrical System ➜ Removing and installing rear lid closure button [E574]

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
– Remove electric hinged tow coupling attachment button -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– The electric hinged tow coupling attachment button must be  
heard to engage.  
3.14  
Removing and installing rear lid clo‐  
sure button [E574]  
The rear lid closure button -E574- will henceforth be referred to  
as “rear lid closure button”.  
Removing  
– Using commercially available plastic wedge, pry out rear lid  
closure button -1- in direction of -arrow-.  
– Remove rear lid closure button -1- until electrical connector  
is accessible.  
– Disconnect electrical connector.  
– Remove rear lid closure button -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– The rear lid closure button must be heard to engage.  
3.15  
Removing and installing rear lid warn‐  
ing buzzer [H32]  
Removing  
– Remove lower rear lid trim ⇒ General body repairs, interior;  
Rep. gr. 70; Luggage compartment trims; Removing and  
installing lower rear lid trim.  
– Pull out spreader rivets -1-.  
138  
Rep. gr.96 - Lights, bulbs, switches - interior  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!