ID.4 2021 ➤
Electrical system - Edition 02.2021
Note
A new housing cover -1- must be used only, if the repair is
carried out for the first time.
– Fit housing cover -1- on headlight.
– Tighten bolts -2-.
– Check headlight settings and adjust headlights if necessary
⇒ Maintenance; Booklet 53.1; Descriptions of work.
Tightening torques
♦ ⇒ Rep. gr. 94; Assembly overview – headlight
2.9
Removing and installing LED module
for daytime running light and side light
[L176]/[L177]
Special tools and workshop equipment required
♦ ESD workplace -VAS 6613-
♦ Torque screwdriver -V.A.G 1624-
The front left headlight -MX1- and front right headlight -MX2-
will henceforth be referred to as “headlight”.
The left LED module for daytime running light and side light
-L176- and right LED module for daytime running light and side
light -L177- will henceforth be referred to as LED module for
daytime running light.
Removal and installation are described for the left vehicle side
as an example.
Removing
– Remove headlight ⇒ Rep. gr. 94; Removing and installing
headlight.
NOTICE
Risk of damage to electrical components.
Electrostatic charge may damage electrical components.
– Work on electrical components must always be carried out
at an ESD workplace.
– Place headlight onto ESD workplace -VAS 6613-.
70
Rep. gr.94 - Lights, bulbs, switches - exterior
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Unscrew bolts -2-.
– Guide LED module for daytime running light -1- out of head‐
light housing until electrical connector is accessible.
– Disconnect electrical connector.
– Remove LED module for daytime running -1-.
Installing
Install in reverse order of removal, observing the following:
NOTICE
Risk of destroying headlight due to ingress of water.
– Check seal between LED module for daytime running and
headlight for damage.
– Make sure seal is properly seated.
– Check headlight settings and adjust headlights if necessary
⇒ Maintenance; Booklet 53.1; Descriptions of work.
Tightening torques
♦ ⇒ Rep. gr. 94; Assembly overview – headlight
2.10
Removing and installing bulb for VARI‐
LIS headlight [L207]/[L208]
Special tools and workshop equipment required
♦ ESD workplace -VAS 6613-
♦ Torque screwdriver -V.A.G 1624-
The front left headlight -MX1- and front right headlight -MX2-
will henceforth be referred to as “headlight”.
2. Headlights
71
2024 VW ID.4 Owner's Manual
