ID.4 2021 ➤
Electrical system - Edition 02.2021
NOTICE
Risk of damage to wiper arm and wiper blade.
– Avoid bending wiper arm and wiper blade.
Removing
– Lift wiper arm off the rear window.
– Swivel wiper blade -1- in direction of -arrow A- out of wiper
arm.
– Release retaining clip -2-.
– Pull wiper blade -1- in -direction of arrow B- out of washer
wiper arm.
Installing
Install in reverse order of removal, observing the following:
•
Push wiper blade into wiper arm until retaining clip is heard
to engage.
4.3
Removing and installing wiper arm
Special tools and workshop equipment required
♦ puller -T10369/5-
Removing
– Switch on ignition.
– Actuate “rear window wipe” function and allow wiper motor
shaft to move to its end position.
– Switch off ignition and electrical consumers.
– Place vehicle key and other entry and start authorisation
systems (e.g. smartphone) outside the vehicle interior.
– Press together cap -2- of wiper arm -1- in direction of
-arrow A-.
46
Rep. gr.92 - Windscreen wash/wipe system
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Fold up cap -2- in direction of -arrow B-, and remove it.
– Loosen nut -3- a few turns.
– Fit puller -T10369/5--A- on wiper arm -2-.
– Position thrust piece -4- on wiper motor shaft.
– Turn spindle -1- clockwise until wiper arm -2- is pulled off
wiper motor shaft.
– Remove puller -T10369/5--A- from wiper arm -2-.
– Unscrew nut -3-.
– Remove wiper arm -2-.
Installing
Install in reverse order of removal, observing the following:
– ⇒ Rep. gr. 92; Adjust wiper arm.
Tightening torques
♦ ⇒ Rep. gr. 92; Assembly overview – rear window wiper sys‐
tem
4.4
Adjusting wiper arm
Procedure
– Loosen wiper arm ⇒ Rep. gr. 92; Removing and installing
wiper arm.
Distance -a- from end of wiper blade to bottom edge of rear
window must be 31 +/-5 mm.
– Adjust wiper blade park position by repositioning wiper arm
-1-.
4. Rear window wiper system
47