ID.4 2021 ➤
Electrical system - Edition 02.2021
Removing
– Remove glove compartment cover ⇒ General body repairs,
interior; Rep. gr. 68; Compartments/covers; Removing and
installing glove compartment cover.
– Release locking lugs -1-.
– Pull out data bus diagnostic interface -3- until electrical con‐
nectors -2- are accessible.
– Disconnect electrical connectors -2-.
– Pull out data bus diagnostic interface -3-.
Installing
Install in reverse order of removal, observing the following:
– If the data bus diagnostic interface has been renewed, con‐
clude the test plan for the renewal of the data bus diagnostic
interface using ⇒ Vehicle diagnostic tester.
3.6
Removing and installing fan for control
unit [V274]
The fan for control unit -V274- will henceforth be referred to as
“fan for control unit”.
Removal and installation are described for a left-hand drive
vehicle as an example.
Removing
– Pull fan for control unit -1- with rubber bushes -3- off bracket
-2-.
168
Rep. gr.97 - Wiring
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Disconnect electrical connector -4-.
– Remove fan for control unit -1-.
Installing
Install in reverse order of removal.
3. Control units
169
2024 VW ID.4 Owner's Manual
