ID.4 2021 ➤
Electrical system - Edition 02.2021
– Remove fuse holder A -3- in direction of -arrow- from bracket
for fuse holder A -2-.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
♦ ⇒ a2.4 nd installing fuse holder A [SA]”, page 152
2.5
Removing and installing fuse holder B
[SB]
The fuse holder B -SB- will henceforth be referred to as “fuse
holder B”.
Removing
– Disconnect battery ⇒ Rep. gr. 27; Disconnecting and con‐
necting battery A.
– Release retaining lugs -arrow-.
– Remove cover for electronics box -1-.
– Pull off cover for electronics box -1- in direction of -arrow-.
154
Rep. gr.97 - Wiring
ID.4 2021 ➤
Electrical system - Edition 02.2021
– Release fasteners -2- in direction of -arrow A-.
– Remove fuse holder B -1- until electrical wires are accessi‐
ble.
– Remove protective cap -2- in direction of -arrow-.
– Unscrew nut of electrical wire -1-.
– Detach electrical wire -1-.
2. Relay carriers, fuse holders, electronics boxes
155
ID.4 2021 ➤
Electrical system - Edition 02.2021
NOTICE
Danger of connectors being inserted in incorrect position.
– Refer to the applicable current flow diagram to obtain infor‐
mation on the exact pin assignment.
– Take photographs of the assignment of the electrical wires
and fuses.
– Disconnect electrical wiring.
– Remove fuse holder B.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
♦ ⇒ a2.5 nd installing fuse holder B [SB]”, page 154
2.6
Removing and installing fuse holder C
[SC]
2.6.1
Removing and installing fuse holder C
[SC], left-hand drive vehicles
The fuse holder C -SC- will henceforth be referred to as “fuse
holder C”.
Removing
– Disconnect battery ⇒ Rep. gr. 27; Disconnecting and con‐
necting battery A.
– Remove dash panel ⇒ General body repairs, interior; Rep.
gr. 70; Dash panel; Removing and installing dash panel.
– Release locking lugs -2- in direction of -arrow A-.
– Remove fuse holder C -1- until electrical wires are accessi‐
ble.
156
Rep. gr.97 - Wiring