Table of Contents > Headlights > Removing and installing LED module for daytime running lights [L377]/[L378]

VW ID.4 Electrical System ➜ Removing and installing LED module for daytime running lights [L377]/[L378]

ID.4 2021 ➤  
Electrical system - Edition 02.2021  
NOTICE  
Risk of destroying headlight due to ingress of water.  
– Check seal between output module and headlight for dam‐  
age.  
– Make sure seal is properly seated.  
– Check headlight settings and adjust headlights if necessary  
⇒ Maintenance; Booklet 53.1; Descriptions of work.  
Tightening torques  
♦ ⇒ Rep. gr. 94; Assembly overview – headlight  
2.13  
Removing and installing light conduc‐  
tor for contour lighting in radiator grille  
[L362]/[L363]  
The light conductor for contour lighting in radiator grille, front left  
-L363-/light conductor for contour lighting in radiator grille, front  
right -L362- will henceforth be referred to as “light conductor”.  
Removing  
– Remove badge at front ⇒ General body repairs, exterior;  
Rep. gr. 66; Lettering and badges; Removing and installing  
badges at front.  
– Disconnect electrical connector -2-.  
– Release retaining clips -3- in direction of -arrow A-.  
– Pull out light conductor -1-.  
Installing  
Install in reverse order of removal, observing the following:  
– The light conductor must be heard to engage.  
2.14  
Removing and installing LED module  
for daytime running lights [L377]/[L378]  
Special tools and workshop equipment required  
♦ Torque screwdriver -V.A.G 1624-  
2. Headlights  
79  
ID.4 2021 ➤  
Electrical system - Edition 02.2021  
The left LED module for daytime running lights -L377- and right  
LED module for daytime running lights -L378- will henceforth be  
referred to as LED module for daytime running lights.  
Removal and installation are described for the left vehicle side  
as an example.  
Removing  
– Remove front left wheel housing liner ⇒ General body re‐  
pairs, exterior; Rep. gr. 66; Wheel housing liner; Removing  
and installing front wheel housing liner.  
– Disconnect electrical connector -3-.  
– Pull off retainer for electrical wire -4-.  
– Unscrew bolts -2-.  
– Remove LED module for daytime running -1-.  
Installing  
Install in reverse order of removal, observing the following:  
Tightening torques  
♦ ⇒ Rep. gr. 94; Assembly overview – LED module for daytime  
running light  
80  
Rep. gr.94 - Lights, bulbs, switches - exterior  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW ID.4 you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!