ID.4 2021 ➤
Electrical system - Edition 02.2021
Installing
Install in reverse order of removal, observing the following:
– If the interface for entry and start system unit has been
renewed, conclude the test plan for the renewal of the inter‐
face for entry and start system using ⇒ Vehicle diagnostic
tester.
Tightening torques
Component
Specified torque
Bolts for interface for entry and 8 Nm
start system
8.5
Removing and installing entry and start
authorisation aerial [R200]/[R201]
The left aerial for entry and start authorisation -R200- and right
entry and start authorisation aerial -R201- will henceforth be
referred to as “aerial”.
Removal and installation are described for the left vehicle side
as an example.
Removing
– Remove front wheel housing liner ⇒ General body repairs,
exterior; Rep. gr. 66; Wheel housing liner; Removing and
installing front wheel housing liner.
– Disconnect electrical connector -1-.
– Release locking lugs -2- using an 8 mm socket.
– Remove aerial -3-.
Installing
Install in reverse order of removal, observing the following:
Tightening torques
♦ ⇒ General body repairs, exterior; Rep. gr. 66; Wheel housing
liner; Assembly overview – front wheel housing liner
102
Rep. gr.94 - Lights, bulbs, switches - exterior
ID.4 2021 ➤
Electrical system - Edition 02.2021
8.6
Removing and installing interior aer‐
ial 1 for entry and start system [R138]
The interior aerial 1 for entry and start system -R138- will
henceforth be referred to as “aerial”.
Removing
– Remove centre console insert ⇒ General body repairs, inte‐
rior; Rep. gr. 68; Centre console; Removing and installing
centre console insert.
– Release fastener -2-.
– Remove aerial -1-.
Installing
Install in reverse order of removal.
8.7
Removing and installing luggage com‐
partment aerial for entry and start sys‐
tem [R137]
Special tools and workshop equipment required
♦ removal wedge set -VAS 895 015-
The luggage compartment aerial for entry and start system
-R137- will henceforth be referred to as “aerial”.
Removing
– Remove lock carrier trim ⇒ General body repairs, interior;
Rep. gr. 70; Luggage compartment trims; Removing and
installing lock carrier trim.
– Use removal wedge set -VAS 895 015- to lever aerial -1- in
direction of -arrow A- off pins.
– Disconnect electrical connector -2-.
8. Entry and start authorisation system
103
2024 VW ID.4 Owner's Manual
